FLUORA-A3 Universal cleaner
It is a colorless or slightly colored odorless liquid. It is a system for effective cleaning (cleaning) of the surface.
It is used to remove heavy dirt from the surface before applying coatings or during technological cleaning. It allows you to eliminate water-insoluble contaminants such as tar, oils, carbon deposits, corrosion, grease deposits, etc., as well as dust, organic deposits, resins, acids.
The compositions of all FLUORA ® cleaners and protective coatings are specially selected to ensure a combination of consistent, reliable performance with ease of cleaning and coating. These products, marketed under the brand name “Epilam FLUORA® “, provide an environmentally sound solution based on a balance of safety, performance and beneficial environmental impact.
Cleaning the surface by applying a liquid composition
“Fluora-A” can be applicated:
a) manually, by available spray or other means of cleaning or coating;
b) pulverization plants, where the pulverization function is carried out evenly.
Recommended cleaning/degreasing by spray, can be wiped with a rag after applying the liquid layer (holding time up to 3 minutes) or a rag soaked in Fluora A.
c) by adding to oils, coolant.
The quality control of cleaning and degreasing is carried out selectively. To do this, the surface is lapped with a clean, dry sheet of white paper. After lapping, the paper should remain white, without stains and streaks. If there are still stains, the cleaning process is repeated.
There is no sharp smell of solvent
After cleaning, the surface becomes resistant to dirt.
Cleans and degreases
They are polymers with efficiency advantages that have long distinguished Epilam ® from competing surfactant manufacturing technologies, such as hydrocarbon and alkaline surfactants.
It is not a flammable.
Do not contain ODS
They are not carcinogens
It does not have an irritating effect
There is a safety data sheet
They can be applied by spray, wetting, roller, brush
Low composition consumption
The calculated amount of composition is determined empirically
Lack of any training requirements
You can work without waiting for drying
Transparent (depends on the surface)
5kg, 10kg, 20kg, 200kg
Scope of application: All areas of industry
Action Some modifications create a thin protective coating, which can significantly reduce the coefficient of adhesion (sticking) and corrosion.
Density at t=20oC 0.8-1.3 g / cm3
Consumption rate of 1 l per 7.10 sq. m. (average)
Holding time before cleaning Up to 5 minutes
Application temperature: -40°C … +50°C
Areas of application FLORA-A3 Universal Cleaner
Industry: Dies, molds, conveyors, extruders, heat exchangers
Salts, acids, bitumen, carbon deposits, coke, rubber, polymers
Paint chambers, paint equipment
Facades, handrails, buildings