- TU: ТУ 2412-003-13868195-2014
- Article: 2207007
- TI: 2207-1831-041
It is a colorless liquid with a low odor. It is a system for effective cleaning of the surface. It is used to remove heavy dirt from the surface before coating or during technological cleaning. It allows you to eliminate water-insoluble contaminants such as tar, oils, carbon deposits, grease deposits, etc., as well as dust, organic deposits and resins, acids.
MODIFICATIONS OF «EPILAM-05 FLUORA-А»
FAST EVAPORATING cleaner
PAINT cleaner (does not leave a film, to camera covering)
URETHANE and POLYMER PAINT cleaner
PLASTIC and COMPOSITES
ALCOHOL substitute (antiseptic)
OIL cleaner, flotator
SULFUR purifier, catalyst
DEPOSITION cleaner, water systems
The composition of all protective coatings "FLUORA®" specially
it is selected in such a way that it provides a combination of consistently reliable performance with ease of coating. These products, sold under the brand name "FLUORA®", provide environmentally sound
a solution based on a balance of safety, performance and environmental impact.
Cleaning the surface by applying the liquid composition “FLUORA® A” should be done:
a) manually, accessible by spraying or other means of cleaning or coating;
b) spraying installations, where the spraying function is carried out uniformly;
Cleaning / degreasing with spraying is recommended, it can be wiped with a cloth after applying a liquid penetrating layer (holding time up to 3 minutes) or a cloth moistened with “FLUORA®-A”.
Control over the quality of cleaning and degreasing is carried out selectively. To do this, the surface is ground with a clean, dry sheet of white paper. After lapping, the paper should remain white, free from stains and streaks. If there are stains, the cleaning process is repeated.
5kg, 10kg, 20kg, 200kg
Areas of use
Stamps, molds, dies
Conveyors, extruders, heat exchangers
Paint booths, painting equipment
Interoperation processing, conservation, UAV
Boards, wires, microcircuits
Facades, handrails, buildings
Oil, gas, acids
All areas of industry
Some modifications create a thin protective coating, which can significantly reduce the adhesion coefficient (adhesion).
Density at t=20ºС
Consumption rate, 1 L
at 7 ... 10 m.kv (on average)
Holding time before cleaning
Up to 5 min
-40°С … +50°С